02/11/2023 06:47:19

TPMS Sensor - ID Learn Procedure

Correction Code 34041100

  • 2023-11-02: Updated Toolbox routine.

Special tools required for this procedure:

Supplier Part Number Description
Tesla 1050759-00-A or newer TOOL, TPMS SERVICE, ATEQ VT30

Setup

  1. Press the Power button and watch the display. When the display shows “ATEQ VT30”, note the version number:
    • If the version is EA1-07, refer to TN-14-92-005, "ATEQ TPMS Tool Firmware Update" to update the tool's firmware.
    • If the version is higher than EA1-07, continue this procedure.
  2. In the Main Menu, use the up and down arrows to select Vehicle Selection, then press the Enter (⏎) button.
  3. Use the up and down arrows to select Tesla, then press the Enter button.
  4. Use the up and down arrows to select Left Front.
  5. Hold the ATEQ tool near the valve stem on the left front tire, then press and hold the Read button until the sensor is read.
  6. Repeat steps 4 and 5 for the 3 remaining tires.
  7. Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
  8. Unlock the vehicle gateway. See Gateway Unlock.
  9. In Toolbox 3, click the Actions tab, type "TPMS-LEARN" into the search field, click PROC_TPMS_X_TPMS-SENSOR-LEARNvia Toolbox: (link)via Service Mode Plus:
    • Chassis ➜ TPMS ➜ Learn ID
    • Chassis ➜ TPMS ➜ Learn ID
    , click Run, and allow the routine to complete.
  10. Disconnect the laptop with Toolbox 3 from the vehicle. See Toolbox 3 (Connect and Disconnect).