24/08/2020 16:07:50

Module - Ultrasonic Door Sensors - LH (Remove and Replace)

Correction Code 11334502

Removal

  1. Remove the rear door trim panel (refer to procedure).
  2. Remove the screws (x2) that secure the module to the door (torque 1.5 Nm).
  3. Disconnect the electrical connectors (x2) from the bottom of the module.
    Informational PurposesAn informational icon, calling your attention
    Note
    Components have been removed in this graphic to aid clarity.
  4. Remove the module from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:

  • Update the vehicle firmware. See Firmware Update.
  • Touch and hold the CALIBRATE button on the Model X touchscreen until the rear doors have been fully calibrated, close completely, and the message "CALIBRATION COMPLETE" is displayed.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the rear door requires adjustment, refer to TN-16-11-002, "Adjusting the Rear Doors (Falcon Wing Doors) on Model X" for instructions.