12/12/2022 09:28:23

Buckle Assembly - 2nd Row - LH (Without 2nd Row Bench Seats) (Remove and Replace)

Correction Code 20057002

Informational PurposesAn informational icon, calling your attention
Note
In the event of an airbag or seat belt tensioner deployment, certain airbag and seat belt components must be replaced, and other components must be inspected for damage. Refer to SRS Inspection and Component Replacement for a specific list of items that must be inspected and replaced.

Remove

  1. Move the 2nd row LH seat fully forward.
  2. Remove the back cover from the seat(refer to procedure).
  3. Move the 2nd row LH seat fully rearward.
  4. Use a pick to release the plastic covers that conceal the screws on the bottom of the seat.
  5. Remove the screws that secure the plastic trim to the bottom of the seat frame.
  6. Use a trim tool to release the clips that secure the lower trim panel to the bottom of the seat frame.
    Informational PurposesAn informational icon, calling your attention
    Note
    On some vehicles, the panel remains as a captive part of the seat and cannot be removed.
  7. Starting at the outer rear corner, peel the lower cushion trim (upholstery) away from the bottom of the seat frame. This allows the lower cushion trim and foam to be lifted in the next step.
  8. Record the locations of any cable ties that secure the buckle assembly harness to the seat frame. Remove the cable ties.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure that new cable ties are installed in the same locations during installation.
  9. Disconnect the buckle assembly harness electrical connector.
  10. Remove and discard the fastener that secures the buckle assembly to the seat frame (torque 45 Nm).

Installation

Installation procedure is the reverse of removal, except for the following:

Install new cable ties to secure the buckle assembly harness to the seat frame.

If the component was replaced due to an internal failure:
  1. Connect a laptop with Toolbox 3 to the vehicle.
  2. Unlock the vehicle gateway. See Gateway Unlock.
  3. In Toolbox 3, click Dashboards > Service Tools > DTCs, and then select SDM or RCM depending on the vehicle Restraint Control Type.
  4. Click Read DTCs to display the DTCs.
  5. Power cycle the vehicle.
  6. Click Clear DTCs to clear the DTCs.
  7. Disconnect Toolbox and remove the laptop from the vehicle.