22/12/2022 09:34:25

Seat Assembly - 2nd Row - RH (With 2nd Row Bench Seats) (Remove and Install)

Correction Code 13054101

Informational PurposesAn informational icon, calling your attention
Note
This procedure is applicable to 5-seat and 7-seat vehicles, but there may be minor differences in interior paneling between the two seating configurations.

Removal

  1. Open all doors, the liftgate, and the hood.
  2. Move both front seats fully forward.
  3. Disconnect 12V power. See Disconnect 12V Power.
  4. Remove the 2nd row floor mat, if equipped.
  5. Fold down the LH 2nd row seat.
  6. Remove the LH and RH lower C-Pillar trim panels. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  7. Remove the LH and RH lower side carpets.
  8. Remove the LH and RH rear sill trim panels. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  9. Remove the 2nd row middle floor panel. See Floor Panel - 2nd Row - Middle (Remove and Replace).
  10. Remove the foam block that supports the floor panel.
  11. Disconnect the seat harnesses.
  12. Release the clip that secures the harness to the RH floor panel bracket.
  13. Release the fasteners that secure the RH 2nd row seat.
    Informational PurposesAn informational icon, calling your attention
    Note
    The next steps require an assistant.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to damage component(s).
  14. With an assistant, carefully remove the seat from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:

Torque the seat fasteners in the following order:
  1. Rear fasteners (torque 45 Nm)
  2. Front fasteners (torque 45 Nm)
  3. Center fasteners (torque 45 Nm)