09/03/2023 20:32:31

Camera - B-Pillar (Remove and Replace)

Correction Code 17261102

Informational PurposesAn informational icon, calling your attention
Note
Perform this procedure only if directed by service bulletin SI-21-17-003. Otherwise, see Applique - B-Pillar - LH (Remove and Replace).

Special tool required for this procedure:

1060071-00-A

Torque wrench 1/4" hexagon (0.2Nm-4Nm)

Removal

  1. Remove the LH B-pillar applique. See Applique - B-Pillar - LH (Remove and Replace).
  2. Remove the screw that attaches the B-pillar camera to the applique.
    Informational PurposesAn informational icon, calling your attention
    Note
    T10 (mini ratchet bit set). Torque 0.67 Nm.
  3. Release the tab that attaches the camera to the applique, and then remove the camera from the applique.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove and discard the old lens rubber gasket if stuck inside the applique.

Installation

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
New B-pillar cameras are pre-configured for LH and RH sides. LH side camera has a yellow sticker and the RH side camera has a blue sticker. Do not swap camera sides, otherwise faults will occur.
  1. Make sure that the camera lens is clean and the rubber gasket is around the lens.
  2. Install the screw that attaches the B-pillar camera to the applique.
    Informational PurposesAn informational icon, calling your attention
    Note
    T10. Torque 0.67 Nm (use special tool 1060071-00-A).
  3. Install the LH B-pillar applique. See Applique - B-Pillar - LH (Remove and Replace).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Camera calibration data must be cleared using the vehicle touchscreen: Controls > Service > Camera Calibration > Clear Calibration.