03/03/2020 13:18:43

Harness - Instrument Panel (Remove and Replace)

Correction Code 17100602

Removal

  1. Remove the cross car beam (refer to procedure).
    Informational PurposesAn informational icon, calling your attention
    Note
    Mark the location of each edge clip before releasing it from the cross car beam.
  2. Remove the instrument panel harness from the cross car beam.

Installation

Installation procedure is the reverse of removal, except for the following:
  • Start by routing the new harness through the space between the HVAC assembly and the steering column.
  • Once the section of harness between the steering column and the driver's door is installed, test-fit the steering column to make sure that the harnesses that connect to it are properly positioned.