12/02/2020 14:02:01

Air Line - Air Suspension - Compressor to Valve Block (Remove and Replace)

Correction Code 31104502

Special tools required for this procedure:

Part Number Description
1079041-00-A Flare nut crowfoot set

Removal

  1. Remove the rear center apron and inspect the vehicle for a Schrader fill valve on the RH shock tower. See Underhood Apron - Center - Rear (Remove and Replace).
    • If the vehicle does not have a Schrader fill valve, install it now. See Fill Valve - Air (Retrofit). Then continue to the next step.
    • If the vehicle has a Schrader fill valve, continue to the next step.
  2. Raise the vehicle, and depressurize the air suspension reservoir. See Air Suspension - Pressurize/Depressurize - Full System .
  3. Remove the front RH wheel arch liner. See Wheel Arch Liner - Front - LH (Remove and Replace) .
  4. Release the fitting for the air suspension compressor line (purple) from the air suspension valve block (torque 3.5 Nm).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Plug the line connection to prevent ingress of moisture or dirt.
  5. Release the nuts that secure the compressor bracket to the body (torque 5 Nm).
  6. Release the compressor bracket from the body.
  7. Use a crowfoot extension to release the fitting for the compressor line (purple) from the compressor (torque 3.5 Nm).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Plug the line connection to prevent ingress of moisture or dirt.
  8. For each released end of an air suspension line, use a flat blade screwdriver to snap off the old collet, and discard the collet and nut (VOSS fitting).

Installation

Installation procedure is the reverse of removal, except for the following:
  1. For each released end of an air suspension line, install and hand-tighten a new collet and nut (VOSS fitting).
    Informational PurposesAn informational icon, calling your attention
    Note
    A plastic plug holds the fitting together before and during installation.
  2. Remove the plastic plug from each new fitting.
  3. Tighten the new fitting (torque 3.5 Nm).
  4. Insert the air compressor line (purple) fully into the fitting, and then lightly pull on the line to make sure that it is secure.
  5. Make sure that all air suspension lines are securely reconnected before continuing.
  6. Refill the air suspension system with Nitrogen. See Air Suspension - Pressurize/Depressurize - Full System .
    Informational PurposesAn informational icon, calling your attention
    Note
    If the compressor to valve block air suspension line was replaced because of a leak, perform the additional steps to purge the accumulated moisture from the dryer.