18/03/2022 01:52:11

Sensor - Parking Distance - S1/S6 - Front (Remove and Replace)

Correction Code 17271042

This procedure applies to front parking sensors 1 and 6.

Removal

  1. Set the air suspension to the "Very High" setting.
  2. Release the clips (x4) that attach the front of the front wheel arch liner to the body.
    Tip: Adjust the angle of the tires as necessary to access the push clips.
  3. Carefully move the front of the wheel arch liner away from the working area.
  4. Remove the bolts (x2) and push clip that attach the front of the fender garnish to the wheel fairing (torque 1.5 Nm).
  5. Release the clips (x8) that attach the front half of the fender garnish to the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not damage the parking sensor while removing the clips.
  6. Gently pull the front of the fender garnish away from the vehicle, and then disconnect the electrical harness from the parking distance sensor.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care when releasing the garnish, as it is still attached to an electrical harness.
  7. Release the remaining clips (x5), and then remove the garnish from the vehicle.
  8. Carefully release the tabs, and then remove the sensor from the garnish.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the o-ring is also removed with the sensor.

Installation

Installation procedure is the reverse of removal.