18/03/2022 01:52:01

Sensor - Parking Distance - S2/S5 - Front (Remove and Replace)

Correction Code 17271032

This procedure applies to front parking sensors S2 and S5.

Removal

  1. Depending on the sensor(s) to be replaced, remove the LH and/or RH front wheel (refer to procedure).
  2. Release the push clips (x7) and the nut (torque 6 Nm) that attach the front portion of the wheel arch liner to the body.
  3. Carefully move the front portion of the wheel arch liner away from the working area.
  4. Disconnect the harness connector from the S2/S5 sensor.
  5. Carefully release the tabs, and then remove the sensor from the sensor housing.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure that the o-ring is also removed with the sensor.

Installation

Installation procedure is the reverse of removal.