18/02/2021 13:26:31

Sensor - Light/Rain (Vehicles with 1st Generation Autopilot) (Remove and Replace)

Correction Code 10200602

This procedure applies to vehicles equipped with 1st generation Autopilot hardware only. For vehicles with 2nd generation Autopilot hardware, refer to procedure 10200702 (refer to procedure).

Removal

  1. Remove the forward facing camera (refer to procedure).
  2. Disconnect the light/rain sensor electrical connector.
  3. On each side of the light/rain sensor, unlatch the spring clip from the plastic tab on the windshield bracket.
  4. Remove the light/rain sensor from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:

Informational PurposesAn informational icon, calling your attention
Note
The light/rain sensor is a one time use component. If the rain/light sensor is removed from the windshield, a new sensor must be installed.
Informational PurposesAn informational icon, calling your attention
Note
Clean the affected areas before installation.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Do not touch the adhesive on the new rain/light sensor.
  1. Test the rain sensor for proper operation:
    1. Sit in the driver's seat.
    2. Set the wipers to the 1st or 2nd intermittent position.
    3. Have an assistant spray the windshield with water.
    4. Check that the wipers sweep when water is sprayed in front of the sensor.
  2. Test the light sensor for proper operation:
    1. Sit in the driver's seat.
    2. On the touchscreen, set the headlights to Auto.
    3. Have an assistant shine a bright light on the sensor.
    4. Check that the touchscreen changes from night to day brightness.
  3. Adjust the forward facing camera (refer to procedure).