12/12/2023 18:42:07

Seat Assembly - 1st Row - LH (Remove and Install)

Correction Code 13040101

  • 2023-12-13: Added a step of releasing the LH front seat belt retractor.
  • 1032900-00-A Torchless Heat Induction Tool
  • 1133787-00-A Seat Belt Release Tool
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
If the 12V power supply is disconnected, do not attempt to open the front doors with door glass in closed position. Failure to follow this instruction could result in door glass shatter.
Informational PurposesAn informational icon, calling your attention
Note
Before disconnecting the 12V power supply, make sure that the driver’s door window is fully open. Failure to follow this instruction could result in vehicle lockout.

Removal

  1. Open the front LH door.
  2. Note the seating profile.
  3. Move the 1st row LH seat fully rearward.
  4. Slide both seat track covers towards the front of the vehicle and remove them from the seat tracks.
  5. Remove and discard the front bolts (x2) that secure the seat to the riser (torque 34 Nm).
  6. Move the seat fully forward.
  7. Slide both seat track covers towards the rear of the vehicle and remove them from the seat tracks.
  8. Remove and discard the rear bolts (x2) that secure the seat to the riser (torque 34 Nm).
  9. Insert the seat belt release tool (1133787-00-A) into the bottom of the retractor to release the LH front seat belt retractor from the LH front pretensioner.
  10. Disconnect 12V power (refer to procedure).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Ensure that the first responder loop has been disconnected for at least 2 minutes.
  11. Carefully lean the seat back and disconnect the electrical connectors from the bottom of the seat.
  12. Apply protective tape around the lower B-pillar trim panel to protect it from damage.
    Informational PurposesAn informational icon, calling your attention
    Note
    The following step requires an assistant.
  13. Remove the 1st row LH seat from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to damage component(s).

Installation

Installation procedure is the reverse of removal, except for the following:

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Replace all patchbolt(s).
  1. Restore the seating profile.