15/05/2023 10:26:51

Latch - Door - Rear - LH (Remove and Replace)

Correction Code 11353702

  • 2023-04-03: Updated hyperlink to TN-16-11-002

Removal

  1. Remove the closeout panel (refer to procedure).
  2. Apply tape to the door to mark the position of the door latch.
  3. Remove the screws that secure the door latch cover (torque 22 Nm). Remove the door latch cover.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Replace all patchbolt(s).
  4. Remove the rear speaker (refer to procedure).
  5. Remove the bolts that secure the cinching actuator to the door (torque 3 Nm).
    Informational PurposesAn informational icon, calling your attention
    Note
    The RH cinching actuator has shim(s) on the lower rearward bolt. Retain these shim(s) for reinstallation with the new cinching actuator.
  6. Disconnect the electrical connector from the door latch.
  7. Lift the cinching actuator and disconnect the electrical connector.
  8. Remove the rear door latch and cinching actuator from the vehicle as an assembly.
  9. Disconnect the latch cable from the actuator to separate the latch.

Installation

Installation procedure is the reverse of removal, except for the following:

Informational PurposesAn informational icon, calling your attention
Note
If the rear door requires adjustment, refer to TN-16-11-002, "Adjusting the Rear Doors (Falcon Wing Doors) on Model X" for instructions.

RH side only: To aid installation, use tape to hold the shim(s) to the lower rearward corner of the cinching actuator.