16/02/2024 14:13:20

Wheel Assembly (Remove and Install)

Correction Code 34015001

  • 2023-06-08: Added tightening torque to installation section.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
If the vehicle has air suspension, activate "Jack" mode on the touchscreen before raising and supporting the vehicle.

Removal

  1. Position the vehicle on a lift but do not lift it at this time.
  2. If equipped, remove the lug nut covers.
  3. Initially loosen the lug nuts (x5) (torque 175 Nm).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not use an impact wrench to loosen tall lug nuts.
    1 Short lug nut
    2 Tall lug nut
  4. Raise and support the vehicle (refer to procedure).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Do not work on an incorrectly supported vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    To avoid personal injury, use appropriate equipment when performing this operation.
  5. Remove the lug nuts (x5) and then remove the wheel.

Installation

Installation procedure is the reverse of removal, except for the following:
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Tighten the lug nuts evenly using a diagonal sequence.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
An impact wrench or electric wrench can be used only during the initial threading of the lug nuts. Use a torque wrench to fully tighten the lug nuts to 175 Nm.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Use a 6 point socket to tighten tall lug nuts. Do not use a 12 point socket or a specialty socket on tall lug nuts.
  1. If the TPMS sensors are not reinstalled in the same locations (for example, when rotating the tires), perform the TPMS sensor ID learn procedure (refer to procedure).