26/07/2023 16:48:05

Switch - 2nd Row - LH (Remove and Replace)

Correction Code 13024402

Removal

  1. Use a pick to release the plastic covers that conceal the screws on the bottom of the seat.
  2. Remove the screws that secure the plastic trim to the bottom of the seat frame.
  3. Use a trim tool to release the clips that secure the lower trim panel to the bottom of the seat frame.
    Informational PurposesAn informational icon, calling your attention
    Note
    On some vehicles, the panel remains as a captive part of the seat and cannot be removed.
  4. Disconnect the electrical harness connector from the switch.
  5. Release the fasteners that secure the switch to the seat cover.
  6. Use a trim tool to remove the switch from the seat cover.

Installation

Installation procedure is the reverse of removal, except for the following:
  • After installation, use Toolbox 3 to disable seat install mode, and then test that the new switch functions properly.
    1. Connect a laptop with Toolbox 3 to the vehicle.
    2. To disable seat install mode, in Toolbox 3, click the Actions tab, type "Seat-Install" into the search field, click PROC_BCREAR_X_SEAT-INSTALL-MODE-OFFvia Toolbox: (link), click Run, and allow the routine to complete.
    3. Disconnect Toolbox and remove the laptop from the vehicle.