02/11/2023 16:39:43

Triple Camera Pitch Adjustment - Forward Facing - 2nd Generation Autopilot (Retrofit)

Correction Code 17232006

Part Number Description
1080559-20-A Adjustable Torque Vario Screwdriver (0.8 - 2.0 Nm)
1126328-00-A TRIPLE CAM RR VIEW MIRROR MOUNT PLATE +2.33 DEGREE
1126328-01-A TRIPLE CAM RR VIEW MIRROR MOUNT PLATE +4 DEGREE
1126328-02-A TRIPLE CAM RR VIEW MIRROR MOUNT PLATE -1.2 DEGREE

Install the triple camera rear view mirror mount plate with integrated pitch adjustment to correct the pitch value when it is out of the pre-calibration specification. Adjust the camera vertical angle based on the image capture result (refer to procedure).

  1. Remove the rear view mirror .
  2. Release the fasteners that attach the mirror cover.
  3. Release the fasteners (x6) that attach the mount plate (torque 0.8 Nm), and then remove and discard the mount plate.
    Informational PurposesAn informational icon, calling your attention
    Note
    Allow the camera to hang by its harness.
  4. Apply two double-sided tape strips to the glare shield to ensure proper connector placement.
    Informational PurposesAn informational icon, calling your attention
    Note
    Failure to secure the connections can cause potential NVH issues.
  5. Install the triple camera rear view mirror mount plate with integrated pitch adjustment onto the glare shield. Install the 6 fasteners in the order shown (torque 0.8 Nm).
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the wire harness is routed correctly. Coaxial connector ends should be pointing towards the right.
  6. Perform a camera pitch verification (refer to procedure).
  7. Remove the adhesive backing that was applied to the glare shield in Step 4, and then secure the connectors into position.
  8. Reinstall the rear view mirror .