15/10/2020 15:39:50
Brake Caliper - Rear - Park Brake - LH (Remove and Replace)
Correction Code 33052002
Note
If the event of a stuck caliper or motor failure, refer to one of these
procedures to release the caliper:
- Rear Park Brake Caliper ReleaseCAUTIONThis method requires replacing the caliper after it has been released.
- Park Brake Caliper - Release - Harness Tool - Through Calipers
- Park Brake Caliper - Release - Harness Tool - Through ECU
Note
Park brake calipers are available with and without new park brake pads.
Removal
- Put the vehicle into Tow mode.
- Remove the LH rear wheel (refer to procedure).
- If the new caliper does not have brake pads: Remove the brake pads from the caliper (refer to procedure).
-
Disconnect the electric parking brake caliper harness connector.
-
Remove and discard the bolts (x2) that secure the caliper to the knuckle (torque
57 Nm).
- Remove the parking brake caliper.
Installation
Installation procedure is the reverse of removal, except for the following:
- Use a M10 x 1.5 tap to clean the mounting holes in the knuckle.
- Clean the affected areas before installation.
- Apply an even layer of Silaramic lubricant (1063021-00-A) to the caliper pad slides. Remove any excess lubricant.
- Burnish the parking brake pads. See Brake Pads - Park Brake - Burnishing.