13/09/2023 00:40:06

Door - Charge Port (Remove and Replace)

Correction Code 44011502

Informational PurposesAn informational icon, calling your attention
Note
The charge port door and motor are removed as an assembly.

Removal

  1. Remove the LH tail light assembly (refer to procedure).
  2. Remove the screws (x3) that secure the charge port door to the tail light assembly (torque 1.25 Nm).
    Informational PurposesAn informational icon, calling your attention
    Note
    The charge port door and motor are removed as an assembly.
  3. Remove the charge port door from the LH tail light assembly. Retain the tail light assembly.

Installation

Installation procedure is the reverse of removal, except for the following:

  1. Ensure that the studs on the tail light align with the slots on the charge port door before installing the screws.
  2. Connect a laptop to the diagnostic port of the vehicle, and then use Toolbox 3 to locally connect to the vehicle. See Toolbox 3 (Connect and Disconnect).
  3. Unlock the vehicle gateway for diagnostic communication. See Gateway Unlock.
  4. Perform Charge Port Door Calibration.
    • For Intel/Tegra vehicles: In Toolbox 3, click the Actions tab, type "Charge Port Door Calibration" into the search field, click PROC_CP_X_DOOR-SENSOR-CALIBRATIONvia Toolbox: (link), click Run, and allow the routine to complete.
    • For Intel vehicles only: On the touchscreen, tap the Service Mode "wrench" (at the bottom of the touchscreen UI), and then tap High Voltage > Charging > Charge Port Door Calibration > Run, and allow the routine to complete.