2025-03-06
Wiper Module (RHD) (Remove and Replace)
Correction Code 17502702
Removal
- Open the RH front door.
- Remove the rear center underhood apron (refer to procedure).
- Remove the HEPA filter (refer to procedure).
-
Disconnect the 12V battery
negative terminal clamp (torque 5 Nm).
-
Disconnect the first
responder loop.
CAUTIONDo not cut the first responder loop.
-
Disconnect the washer hose
from the nipple on the LH side of the vehicle.
-
Lift up the front of the
cowl screen and release the drain hose.
-
Disconnect the wiper arm hoses from the cowl screen.
-
Remove the nuts (x3) (torque
35 Nm) that attach the wiper arms to the coil screen.
-
Remove the clips (x2) on the LH and RH outer hood hinge covers, and then
remove the covers.
-
Remove the push pins (x5)
that secure the cowl screen to the vehicle, and then move the cowl screen
away from the windshield..
-
Remove the clip (x1) that attaches the HEPA filter duct to the vehicle, and
then remove the duct.
-
Remove the clips and the
bolt (torque 9 Nm) that secure the cowl screen support bracket to the body,
and then remove the cowl screen support bracket from the vehicle.
-
Release the bolts (x3)
(torque 9 Nm) that secure the wiper module to the body.
- Gently pull the wiper module forward, and then disconnect the electrical connector from the wiper module.
- Remove the wiper module from the vehicle.
Installation
Installation procedure is the reverse of removal.