26/07/2023 16:53:17

Door Assembly - Rear Lower - LH (Remove and Install)

Correction Code 10106501

Remove

  1. Prepare a padded surface to set the door onto after it is removed.
  2. Remove the rear door upper trim panel (refer to procedure).
  3. Remove the lower rear door trim panel (refer to procedure).
  4. Fully open the rear door.
  5. Disconnect the harnesses and release the ground strap on the lower door harness (torque 9 Nm).
  6. Support the rear door.
  7. Have one or more assistants support the entire weight of the lower rear door.
  8. Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    After the next step, the door will only be supported by the assistants.
  9. Release the 4 bolts that secure the lower door to the upper door (torque 24 Nm).
  10. Set the door onto the padded surface.

Installation

Installation procedure is the reverse of removal, except for the following:

  • Touch and hold the CALIBRATE button on the Model X touchscreen until the rear doors have been fully calibrated, close completely, and the message "CALIBRATION COMPLETE" is displayed.
  • Connect a laptop with Toolbox 3 to the vehicle.
  • Unlock the vehicle gateway. See Gateway Unlock.
  • Choose from:
    • For the driver side rear door, in Toolbox 3, click the Actions tab, type "DRV_USS_DOOR" into the search field, click TEST-SELF_BCFALCD_DRV_USS-DOOR-WITH-OBSTACLEvia Toolbox: (link), click Run, and allow the routine to complete.
    • For the passenger side rear door, in Toolbox 3, click the Actions tab, type "PAS_USS_DOOR" into the search field, click TEST-SELF_BCFALCP_PAS_USS-DOOR-WITH-OBSTACLEvia Toolbox: (link), click Run, and allow the routine to complete.
  • Disconnect Toolbox and remove the laptop from the vehicle.