21/02/2024 00:15:18

Mount - Front Drive Unit - RH (Remove and Replace)

Correction Code 39012402

  • 2024-02-21: Added torque information for the 4 middle bolts that attach the RH drive unit mount to the body.
Table 1. Special tools required for this procedure:
Supplier Part Number Description
Bosch FMG-750 Transmission Jack 750 Kg Europe only
Tesla 1053350-00-A Transmission Jack Cradle Adapter Plate Europe only
Tesla 1063141-00-A 1/2 Ton Economy Transmission Jack North America, APAC only
Tesla 1048391-00-B Drive Unit Dual Motor Cradle - Delrin white
Tesla 1056566-00-A Locating Shim Set, Front Motor
Tesla 1126496-00-B Wrench, Torque+Angle, 3/8" Dr
Tesla 1139297-00-A SKT, 3/8" DR, Low Profile, 15mm
Tesla 1083189-**-A Tool, ATF oil refiller

Remove

  1. Remove the front drive unit. See Drive Unit - Front (1st Generation) (Remove and Install).
  2. Remove the nuts (x2) that secure the HV harness to the body (torque 4 Nm).
  3. Loosen the rear bolt that secures the drive unit mount to the body (torque 120 Nm).
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not fully remove the bolt.
  4. Loosen the front bolt that secures the drive unit mount to the body (torque 120 Nm).
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not fully remove the bolt.
  5. While supporting the drive unit mount, remove the remaining middle bolts (x4) that secure the drive unit mount to the body (torque 60 Nm+90 degrees), and then remove the drive unit mount from the vehicle.

Installation

Installation procedure is the reverse of removal.