03/03/2020 13:18:43

Brightwork - Upper - Front - LH (Remove and Replace)

Correction Code 12200502

Removal

  1. Remove the B-pillar applique (refer to procedure).
  2. Partially remove the primary seal to gain access to the screws that secure the brightwork to the seal carrier extrusion.
  3. Partially remove the upper brightwork seal.
  4. Remove the screws (x7) that secure the brightwork to the seal carrier extrusion (torque 2.5 Nm).
    Informational PurposesAn informational icon, calling your attention
    Note
    Components have been removed in this graphic to aid clarity.
  5. While holding down the brightwork, pull the rear lower corner of the brightwork away from the vehicle to release the retention clips (x2).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not pull on the front lower corner of the brightwork; this can damage or warp the brightwork.
    Correct Incorrect
  6. Remove the front upper brightwork from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:

Tip: Carefully twist the upper brightwork seal away from the vehicle to expand the surface area of the seal. This makes it easer to install the brightwork.