26/07/2023 16:52:57

Track - Inner - 2nd Row Seat - LH (Remove and Replace)

Correction Code 13020202

Special tools required for this procedure:

Supplier Part Number Description
Tesla 1054190-00-A Feeler Gauges
Tesla 1085692-00-A MX 2nd Row Seat Track Removal Kit

Removal

  1. Remove the sliding carpet assembly (refer to procedure).
  2. Remove the cable ties that secure the harnesses to the track.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure that new cable ties are installed in the same locations during reinstallation.
  3. Remove the nuts that secure the outer track to the seat (torque 30 Nm).
  4. Remove the track from the vehicle.

Track Alignment

  1. Combine the 6 mm and 5.5 mm feeler gauges to create an 11.5 mm gauge. Insert the gauge against the stop at the rear of the new inner track.
    1 11.5 mm feeler gauge against stop at rear of track
  2. Insert the square bit into the driveshaft hole in the new track, then install the bit into a drill.
  3. Use the drill to move the gearbox rearward until it contacts the feeler gauge.
  4. Remove the square bit from the gearbox, but leave it inserted in the drill.
  5. Insert the 11.5 mm feeler gauge against the stop at the rear of the out track.
  6. Insert the square bit into the driveshaft hole in the seat motor.
  7. Use the drill to spin the motor so that the gearbox on the outer track moves rearward until it contacts the feeler gauge.

Installation

  1. Loosely install the nuts that secure the inner track to the seat, but do not fully torque them at this time.
    Informational PurposesAn informational icon, calling your attention
    Note
    The track is fully torqued after the seat is installed in a later step.
  2. Use cable ties to secure the harnesses to the plastic bracket on the track.
  3. Reinstall the sliding carpet assembly (refer to procedure).
  4. Connect a laptop with Toolbox 3 to the vehicle.
  5. Unlock the gateway. See Gateway Unlock.
  6. To disable seat install mode, in Toolbox 3, click the Actions tab, type "Seat-Install" into the search field, click PROC_BCREAR_X_SEAT-INSTALL-MODE-OFFvia Toolbox: (link), click Run, and allow the routine to complete.
  7. In Toolbox 3, click the Actions tab, type "PROC_BCS2L" in the search field, click PROC_BCS2L_R2-L_CALIBRATE-S2L-TRACKvia Toolbox: (link), click Run, and allow the routine to complete.
  8. Disconnect Toolbox and remove the laptop from the vehicle.