03/07/2024 16:10:04
Pinch Sensor (1st row) - LH (Remove and Replace)
Correction Code 11351202
Remove
- Remove the front door closeout panel (refer to procedure).
-
Use a plastic trim tool to remove the push clips (x6) that secure the pinch
sensor to the door.
CAUTIONCare must be taken to avoid damage to paintwork and exterior trim.
- Slide the pinch sensor trim out from under the door seal.
-
Release the pinch sensor harness grommet by pulling it away from the door. Pull
the pinch sensor harness out through the grommet in the rear of the door
shell.
-
Reach in through the door cavity and release the fir tree clip that secures the
pinch sensor harness to the door.
- Remove the pinch sensor from the vehicle.
- Perform any necessary post-repair operations.
Installation
Installation procedure is the reverse of removal, except for the following:
CAUTION
Replace any broken clips.
- Ensure proper operation of the pinch sensor.