22/02/2024 13:35:11

Harness - Subframe - Rear (Remove and Replace)

Correction Code 17102002

  • 2024-02-19: Updated references to procedures.

Removal

  1. Remove the rear subframe. See Subframe Assembly - Rear (Remove and Install).
    Informational PurposesAn informational icon, calling your attention
    Note
    Mark the location of each edge clip before releasing it from the subframe.
  2. Disconnect the harness connectors for the LH and RH wheel speed sensors.
  3. Disconnect the harness connectors for the LH and RH ride height sensors.
  4. Use a trim tool to separate the subframe harness clips from the drive unit.
  5. Remove the subframe harness.

Installation

  1. Install the subframe harness to the subframe, and then fasten the subframe harness clips to the drive unit.
  2. Connect the harness connectors for the LH and RH ride height sensors.
  3. Connect the harness connectors for the LH and RH wheel speed sensors.
  4. Install the rear subframe. See Subframe Assembly - Rear (Remove and Install).
  5. Check the vehicle wheel alignment, and adjust if necessary. See Four Wheel Alignment Check.