14/02/2022 02:42:05

Insulator - Wheelhouse - Rear - LH (Remove and Replace)

Correction Code 15307102

Remove

  1. Open the LH front door, both falcon doors and the trunk.
  2. Activate 'Jack Mode' (refer to procedure).
  3. Remove the LH lower C-pillar trim (refer to procedure).
  4. Remove the LH and RH rear trunk side garnish (refer to procedure).
  5. Remove the rear trunk sill trim (refer to procedure).
  6. Remove the trunk board.
  7. Remove the rear trunk front floor carpet.
  8. Remove the rear trunk rear wall trim (refer to procedure).
  9. Remove the LH mid C-pillar trim (refer to procedure).
  10. Remove the LH upper C-pillar trim (refer to procedure).
  11. Remove the third row seat LH seat bracket cover.
  12. Remove the LH rear trunk side trim (refer to procedure).
  13. Remove the LH mid zone C-pillar bracket (refer to procedure).
  14. Remove the LH load floor support bracket.
  15. Remove the charger duct.
  16. Remove the clip that attaches the LH C-pillar outlet duct to the vehicle, and then remove the duct.
  17. Release the tabs (x2) that attach the the LH C-pillar feeder duct to the body, and then remove the duct.
  18. Remove the 3rd row seats (refer to procedure)
  19. Remove the 3rd row floor carpet.
  20. Remove the bolts (x9) that attach the LH inner rear wheelhouse reinforcement to the body (torque 25 Nm), and then remove the reinforcement.
  21. Remove the underhood storage unit (refer to procedure).
  22. Remove the HEPA filter (refer to procedure).
  23. Disconnect 12V power (refer to procedure).
  24. Remove the rear body controller module (refer to procedure).
  25. Remove the rear body controller bracket.
  26. Remove the electric park brake module (refer to procedure).
  27. Remove the charger (refer to procedure).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Make sure that you perform the vehicle isolation procedure while removing the charger.
  28. Release the clip that attaches the rear LH D-pillar accelerometer harnes to the body and disconnect the connector from the LH D-pillar accelerometer.
  29. Disconnect the LH taillight connector.
  30. Remove the park assist module (refer to procedure).
  31. Remove the HV harness from the charge port:
    1. .Disconnect the charge port logic connector.
    2. Remove the charge port harness cap.
    3. Remove the bolts (x3) that attach the HV harness to the charge port (torque 5 Nm).
  32. Disconnect the connectore from the B/C pillar accelerometer.
  33. Release all rear LH B/C/D pillar harness clips.
  34. Disconnect the rear LH D-pillar harness connectors (3x electrical harness connectors, 4x coax connectors), and then release the clips that attach the LH rear harnes to the body.
  35. Release the clips (x2) that attach the charger coolant hose to the body.
  36. Remove the 2nd row middle floor panel (refer to procedure).
  37. Remove the LH rear wheelhouse insulator from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following: