2026-08-09

Strut - Rear Door - Primary - LH (Remove and Replace)

Correction Code 11331002

Removal

Apply protective tape onto the racetrack trim to prevent damage.
Remove the upper door trim bracket:
- Front: (refer to procedure)
- Rear: (refer to procedure)
Support the rear door.

Warning
Ensure that the door is fully supported before continuing. Either have an assistant support the full weight of the door or use a pole jack.
Disconnect the primary strut harness, then release the 2 clips that secure the harness to the door.
Release the strut from the door.
Release the strut from the body.

Warning

Continue to support the door until the new strut is installed.

Installation procedure is the reverse of removal, except for the following:

Touch and hold the CALIBRATE button on the Model X touchscreen until the rear doors have been fully calibrated, close completely, and the message "CALIBRATION COMPLETE" is displayed.