03/03/2020 13:18:43
Battery Coolant Pump 1 (1st Generation) (Remove and Replace)
Correction Code 18308502
This procedure is for vehicles built through April 24, 2019. For vehicles built after April 24, 2019, see Battery Coolant Pump 1 (2nd Generation) (Remove and Replace).
Coolant pump locations:
Removal
- Disconnect 12V power. See Disconnect 12V Power .
- Remove the front subframe skid bar. See Skid Bar - Front Subframe (Remove and Replace)
-
Disconnect the low voltage
electrical connector from the coolant pump.
- Slide the pump off the bracket.
-
Clamp both coolant hoses.
NotePlace absorbent material or an appropriate receptacle underneath the pump to catch any coolant that is spilled in the next step.
- Release the hoses from the pump.
- Remove the pump from the vehicle.
Installation
Installation procedure is the reverse of removal, except for the following:
Refill and bleed the cooling system. See Cooling System - Partial Refill and Bleed.