03/03/2020 13:18:43

Wiper Blades - Adjust

Correction Code 17501700

Special tool required for this procedure:

Supplier Part Number Description
Tesla 1033877-00-B Wiper Adjustment Tool
If the wiper blades streak or chatter during cycling, perform the following:
  1. Use the touchscreen to set the wipers to Service Mode.
  2. Clean the wiper blades thoroughly with isopropyl alcohol wipes or equivalent.
  3. Clean the windshield thoroughly with isopropyl alcohol wipes or equivalent. Check that the windshield has no dirt, residue, commercial coatings, etc.
  4. Spray the windshield with the washer jet.
  5. Cycle the wiper blades on high. If streaking or chatter persists, complete the following procedure or procedures that address your issue.

Perform the following if:

  • Streaking persists on either wiper blade
  • Chatter persists on the driver's-side wiper blade
  1. Use the touchscreen to turn off wiper service mode.
  2. Remove the affected wiper blade (refer to procedure).
  3. Check that the measurement plate on the wiper arm adjustment tool rotates freely in its setting. If it does not, lightly loosen the plate screw using a Hex tool.
  4. Loosen the adjustment pin on top of the wiper arm adjustment tool.
  5. Slide the tool onto the end of the exposed wiper arm.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    The end of the wiper arm can scratch the glass. Make sure it does not make contact with the glass.
  6. Remove the cloth from underneath the end of the wiper arm.
  7. Tighten the adjustment pin to secure the tool onto the arm. Make sure both points on the plastic sit on the windshield.
  8. Check that the arm is within specifications:
    • LHD vehicle, driver's side: 1.5 degrees +/- 3 degrees
    • LHD vehicle, passenger's side: 1.7 degrees +/- 3 degrees
    • RHD vehicle, driver's side: -1.5 degrees +/- 3 degrees
    • RHD vehicle, passenger's side: -1.7 degrees +/- 3 degrees
  9. If the arm is not within specifications, set an open-ended wrench (24 mm) onto the tool and adjust the arm until it is within specifications.
  10. Remove the tool from the arm.
  11. Reinstall the wiper blade.
  12. If streaking or chatter still persists, replace the wiper blade (refer to procedure).