10/12/2024 15:30:37

Fixed Glass - Rear Door - LH (Remove and Replace)

Correction Code 11501602

  • 2024-12-10: Added new caution about Pre-Installation Glass Inspection service requirements.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
New glass components (windshield, roof, door, and fixed glass) must be inspected before installation to meet Tesla’s internal standards of quality. Perform the inspection described in Pre-Installation Glass Inspection before beginning this procedure.

Removal

  1. Remove the rear door inner belt seal (refer to procedure).
  2. Remove the upper clips (x4) that secure the pinch sensor to the door.
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to completely remove the pinch sensor.
  3. Release the upper and rear fasteners that secure the fixed glass (torque 3.5 Nm):
  4. Release the lower fasteners that secure the fixed glass (torque 4.5 Nm):

Installation

Installation procedure is the reverse of removal, except for the following:

Apply P-80 emulsion to the seals on the new fixed glass.