13/12/2022 18:47:21

Door Mirror Assembly - LH (Remove and Replace)

Correction Code 12091102

Removal

  1. Remove the 4 underhood aprons. SeeAssembly - Underhood Apron - Front (Remove and Replace) and Underhood Apron - Center - Rear (Remove and Replace).
  2. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  3. Remove the HEPA filter. See Filter - HEPA (Remove and Replace).
  4. Disconnect 12V power. See Disconnect 12V Power.
  5. Remove the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Install).
  6. Remove the inner belt seal. See Seal - Inner Belt - Front Door - LH (Remove and Replace).
  7. Disconnect the door mirror connectors (x2).
  8. Remove and discard the bolts (x4) that attach the module bracket to the LH front door.
  9. Use a plastic trim tool to pry up along the outer edge of the LH door mirror cover.
  10. Lift upward to release the tabs that attach the LH door mirror cover to the LH door mirror, and then remove the mirror cover.
  11. Remove the front door fixed glass. See Fixed Glass - Front Door - LH (Remove and Replace).
  12. Remove the final bolt that attaches the mirror assembly to the front door and remove the mirror assembly.

Installation

  1. Position the door mirror onto the assembly and then loosely install the bolts that attach the mirror to the front door.
  2. Install the front door fixed glass. See Fixed Glass - Front Door - LH (Remove and Replace).
  3. Torque the bolt that attaches the mirror to the front door.
    9 Nm (6.6 lbs-ft)
  4. Install the LH door mirror cover, and then press down to fasten the tabs that attach the cover to the mirror.
  5. Connect the door mirror connectors (x2).
  6. Install the inner belt seal. See Seal - Inner Belt - Front Door - LH (Remove and Replace).
  7. Position the module bracket, route the harness and then install new bolts (x4) that attach the bracket to the LH front door.
    6 Nm (4.4 lbs-ft)
  8. Install the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Install).
  9. Connect 12V power. See Disconnect 12V Power.
  10. Install the HEPA filter. See Filter - HEPA (Remove and Replace).
  11. Install the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  12. Install the 4 underhood aprons. SeeAssembly - Underhood Apron - Front (Remove and Replace) and Underhood Apron - Center - Rear (Remove and Replace).