Model X Service Manual

1601 - HV Battery Assembly

Aero Shield Support Tab - HV Battery 1.0/1.5 (Remove and Replace)
Correction Code 16012022 (HV Battery already removed), 16012032 (HV Battery not yet removed)
Aero Shield Support Tab - HV Battery 2.0 (Remove and Replace)
Correction Code 16012042 (HV Battery already removed), 16012052 (HV Battery not yet removed)
HV Battery (AWD) (Remove and Install)
Correction Code 16010201
HV Battery (AWD) (Remove and Replace)
Correction Code 16010202
HV Battery Blanket (Remove and Replace)
Correction Code 16014002
HV Battery Coolant - Drain and Refill
Correction Code 16010005

Parent topic: 16 - BATTERY SYSTEM

2015-2020 Model X Service Manual
Release Notes
- Current Release Notes
- Release Notes Archive
GENERAL INFORMATION
00 - INSPECTION AND SERVICE
10 - BODY
11 - CLOSURE COMPONENTS
12 - EXTERIOR FITTINGS
13 - SEATS
14 - INSTRUMENT PANELS AND PEDALS
- 1405 - Instrument Panel
15 - INTERIOR TRIM
16 - BATTERY SYSTEM
17 - ELECTRICAL
18 - THERMAL MANAGEMENT
20 - SAFETY AND RESTRAINT
21 - INFOTAINMENT
30 - CHASSIS
- 3001 - Chassis and Subframes
31 - SUSPENSION
32 - STEERING
- 3201 - Steering Rack and Lower Column
- 3205 - Upper Column, Steering Wheel
33 - BRAKES
34 - WHEELS AND TIRES
39 - FRONT DRIVE UNIT
40 - REAR DRIVE UNIT
44 - HIGH VOLTAGE SYSTEM
50 - EXTERNAL CHARGING CONNECTORS

Torque Calculator Values

T1 (Original torque spec)

L (Distance from center of wrench grip to center of square drive tang)

E (Horizontal distance from center of square drive tang to center of fastener)

Note

If the angle from the extension to the torque wrench is greater than 90° (Figure 2), input E as a positive number.
If the angle from the extension to the torque wrench is less than 90° (Figure 3), input E as a negative number.
If the angle from the extension to the torque wrench is exactly 90°, this calculator is not needed. Torque the fastener to T1.

T2 (Final torque setting)