03/03/2020 13:18:43

Trim - Touchscreen Surround (Remove and Replace)

Correction Code 14053002

Special tool required for this procedure:

Supplier Part Number Description
Tesla 1065660-00-A ESD FOAM CONTAINER FOR MEDIA CONTROL UNIT

Removal

  1. Remove the MCU (refer to procedure).
  2. Gently place the MCU on the foam ESD container with the touchscreen facing down.
  3. Release the Bluetooth antenna from the cable tie. If necessary, cut the cable tie.
    Informational PurposesAn informational icon, calling your attention
    Note
    Components have been removed in this graphic to aid clarity.
  4. Remove the screws (x6) that secure the touchscreen surround to the MCU (torque 4 Nm).
  5. Lift the MCU and remove the touchscreen surround.
  6. Gently place the MCU back down on the foam ESD container with the touchscreen facing down.
  7. Remove the screws (x2) that secure the hazard warning switch to the touchscreen surround (1 Nm), and then remove the hazard warning switch from the touchscreen surround.
    Informational PurposesAn informational icon, calling your attention
    Note
    Components have been removed in this graphic to aid clarity.
  8. Remove the screws (x2) that secure the glove box switch to the touchscreen surround (1 Nm), and then remove the glove box switch from the touchscreen surround.
    Informational PurposesAn informational icon, calling your attention
    Note
    Components have been removed in this graphic to aid clarity.

Installation

Installation procedure is the reverse of removal, except for the following:

  1. Transfer both switches to the new touchscreen surround.
  2. If necessary, replace the cable tie that secures the Bluetooth antenna. Remove any excess tie.