20/02/2024 00:16:11
Fuse Box - Underhood (Remove and Replace)
Correction Code 17012402
- 2024-02-15: Added reference to rework of fuse box, if needed.
Remove
- Disconnect 12V power (refer to procedure).
-
Disconnect the pyrotechnic fuse harness.
- Remove the fuse box cover.
-
Release the nut that secures the harness to the 250 A fuse (torque 15 Nm).
-
Release the nut that secures the harness to the 80 A fuse (torque 6 Nm).
-
Release the nut that secures the 12V battery positive cable to the fuse box
(torque 15 Nm).
-
Release the nut that secures the harness to the 125 A fuse (torque 6 Nm).
-
Release the nut that secures the harness to the 125 A fuse (torque 6 Nm).
- Release the 4 clips at the rear of the fuse box that secure it to the bracket.
- Gently rotate the fuse box to gain access to the underside.
-
On each side of the fuse box, rotate the clip inboard to release the
harness.
-
Rotate the clip on the center harness toward the RH side of the vehicle to
release it from the fuse box.
-
Remove the fuse box from the vehicle.
Installation
Note
Certain versions of fuse box part number 1034405-02 have
the middle connector (X002) at the underside of the fuse box reversed/mirrored
compared to the original fuse box middle connector (see image). If this is the
case, the replacement fusebox must be reworked. See Fuse Box - Underhood (Rework) for additional
instructions and separately add Correction Code 17012407 to the Service
Visit.
Installation procedure is the reverse of removal.