01/09/2022 20:15:21

Charge Port (Retrofit) (China)

Correction Code 44103006

Informational PurposesAn informational icon, calling your attention
Note
This procedure is only for below parts:
  • MS: 1103140-00-F,CP DOOR ASY, ICP-GB, MS
  • MX: 1048647-00-B, TRIM ASY,CP,GB,MDLX
  1. Cut 2 pieces of net -pad, and glue the 2 pads toogether .
    Informational PurposesAn informational icon, calling your attention
    Note
    Size of the net-pad is 32.5mm-35mm.
  2. Add Special T Glue to the adhesive side of the stacked net pad.
  3. Gently use needle nose pliers to install the combo pads to the charger port.
    Informational PurposesAn informational icon, calling your attention
    Note
    The following picture shows an older version, the newer version might have a sliding tab.
  4. Losse screws in the charger port door to adjust the plate .
  5. Fasten the screws (torque 1.3 Nm).
  6. Install 3M double-sided adhesive tape to chargeport door.