31/01/2024 17:21:36

Hinge - Door - Front - Lower - LH (Remove & Replace)

Correction code 11336602

Removal

  1. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  2. Remove the HEPA filter. See Filter - HEPA (Remove and Replace).
  3. Disconnect 12V power. See Disconnect 12V Power.
  4. Apply tape to the door and body to mark the location of the LH lower door hinge to aid during installation.
  5. Apply tape to the rear part of the LH front fender.
  6. Support the LH front door with a floor jack.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Put a soft object in between the floor jack's saddle and the door to prevent damage to the paint.
  7. Remove the bolts (x2) that attach the LH front door lower hinge to the door assembly (torque 24 Nm).
  8. Remove the bolts (x2) that attach the LH front door lower hinge to the body (torque 25 Nm).
  9. Remove the LH front lower door hinge.

Installation

Installation procedure is the reverse of removal, except for the following:
  • After installing the hinge, check the gaps between the front door and the surrounding panels.
    Informational PurposesAn informational icon, calling your attention
    Note
    Refer to CVIS for gap/flush targets.
  • Apply touch up paint to the hinge bolts as required.
  • Use the touchscreen to calibrate the falcon doors.
    Informational PurposesAn informational icon, calling your attention
    Note
    Falcon door calibration is required after each 12V disconnection.