16/09/2022 10:16:59
Steering Rack (RHD) (3rd Generation) (Remove and Replace)
Correction Code 32014102
This procedure is for vehicles built after April 24, 2019.
See also:
Vehicles built through October 16, 2016: See Steering Rack (RHD) (1st Generation) (Remove and Replace)
Vehicles built between October 16, 2016 and April 24, 2019: See Steering Rack (RHD) (2nd Generation) (Remove and Replace)
Removal
- Remove the 2nd generation front subframe assembly (RHD) from the vehicle. See Subframe Assembly - Front - 2nd Generation (RHD) (Remove and Install)
-
Remove and retain the front stabilizer bar assembly from the subframe.
-
Remove the bolts (x3) that attach the steering rack to the front subframe assembly, and then remove the steering rack from the subframe.
Installation
-
Install the bolts (x3) that attach the steering rack to the front subframe assembly (torque 175 Nm).
-
Install the front stabilizer bar into position for installation on the front subframe assembly.
- Put the front subframe assembly with the powertrain table/subframe fixture under the vehicle for installation.
- Install the front subframe assembly onto the vehicle. See Subframe Assembly - Front - 2nd Generation (RHD) (Remove and Install)
- Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust as a separate activity. See Alignment Requirement - Suspension.