01/12/2022 09:15:15

Light - Map - Front (Remove and Replace)

Correction Code 17350312

Removal

  1. Remove the headliner. See Headliner (Remove and Replace) .
  2. Place the headliner on a clean work surface with the upholstered side facing down.
  3. Disconnect the headliner electrical harness from the map light connector.
  4. If installed, disconnect the intrusion sensor electrical harness connectors (x2) from the intrusion sensor module.
  5. Release the clips (x4) that attach the map light to the headliner, remove the map light from the headliner, and then pass the map light connector through the headliner.
    Informational PurposesAn informational icon, calling your attention
    Note
    If installed, make sure that the intrusion sensor connectors do not catch on the headliner.
  6. If installed, release the clips (x2) that attach each intrusion sensor to map light, and remove the sensors (x2) from the map light.

Installation

  1. If previously removed, install the intrusion sensors (x2) into the map light, and then fasten the clips that attach each sensor to the map light.
  2. Pass the map light connector through the headliner, install the map light into the headliner, and then fasten the clips (x4) that attach the map light to the headliner.
    Informational PurposesAn informational icon, calling your attention
    Note
    If installed, make sure that the intrusion sensor connectors pass through the headliner.
  3. If installed, connect the intrusion sensor electrical harness connectors (x2) to the intrusion sensor module.
  4. Connect the headliner electrical harness to the map light connector.
  5. Install the headliner. See Headliner (Remove and Replace) .