10/05/2022 03:28:03

Fascia Assembly - Front (Remove and Install)

Correction Code 10011001

Removal

  1. Prepare a soft, clean area on which to set the fascia after it is removed.
  2. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace) .
  3. Remove the LH and RH fender garnishes (refer to procedure).
  4. On both sides of the vehicle, remove the screw that secures the front fascia to the fender (torque 1.5 Nm).
  5. Remove the front aero shield (refer to procedure).
  6. Remove the bolts (x2) that secure the top of the front fascia to the upper grille (torque 4 Nm).
  7. Release the rear portion of the fascia by pulling the rear corners away from the fenders.
  8. Starting on the LH side of the vehicle, release the clips that secure the front fascia by pulling the fascia up and away from the vehicle.
  9. Disconnect the harness connector on the RH side of the vehicle.
  10. With an assistant, remove the front fascia from the vehicle.

Installation

Installation procedure is the reverse of removal.