03/03/2020 13:18:43

Switch - Rear Door - Door Mounted - LH (Remove and Replace)

Correction Code 11333002

Removal

  1. Remove the rear door closeout panel (refer to procedure).
  2. Move the window regulator motor out of the working area.
  3. Working from inside the door cavity, disconnect the electrical connector from the rear door switch.
  4. While holding the white connector in place, loosen the plastic wing nut until the door switch is free. Remove the plastic wing nut from the door.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to damage component(s).
  5. Working from outside of the vehicle, remove the rear door switch.

Installation

Installation procedure is the reverse of removal, except for the following:

Informational PurposesAn informational icon, calling your attention
Note
The hole in the door is notched; ensure that the tab on the door switch aligns with the notch in the hole.