10/05/2022 01:04:54

Trim - Back Rest - 2nd Row - LH (Bench Seat) (Remove and Replace)

Correction Code 13086302

Removal

  1. Remove the RH 2nd row bench seat from the vehicle, and then remove the seat cushion. See Trim - Cushion - 2nd Row - LH (Bench Seat) (Remove and Replace).
  2. Loosen the bolt that attaches the center seat belt to the frame (torque 45 Nm), and then remove the center seat belt.
  3. Remove the back board. See Back Board – Seat Back – 2nd Row – LH (Bench Seat).
  4. Loosen the bolt that attaches the lower stop to the LH rear bench seat (torque 5 Nm), and then remove the lower stop.
  5. Disconnect the seat heater electrical connector.
  6. Remove the fasteners (x2) that attach the airbag to the seat frame (torque 20 Nm).
  7. Reinstall the release handle and return the RH bench seat to an upright position.
    Informational PurposesAn informational icon, calling your attention
    Note
    Install the release handle without the spring clip.
  8. Push the bottom of the seat back trim forward.
  9. Remove the outer seat belt escutcheon.
  10. Remove the center seat belt escutcheon.
  11. Lift up the top part of the seat back trim, feed the outer and center seat belts through the seat cushion pass through, and then remove the back trim from the seat frame.

Installation

Installation procedure is the reverse of removal, except for the following:

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Replace any broken clips.