Model X Service Manual

1222 - Spoiler

Active Spoiler Assembly (Remove and Install)
Correction Code 12220101
Active Spoiler Assembly (Remove and Retrofit)
Correction Code 12220102
Wing - Upper - Active/Passive Spoiler (Remove & Install)
Correction Code 12222201
Wing - Upper - Active/Passive Spoiler (Remove & Replace)
Correction Code 12222202
Hinge - Active Spoiler - LH (Remove and Replace)
Correction Code 12221502
Wing - Lower - Active Spoiler (Remove and Replace)
Correction Code 12222302
Motor - Active Spoiler (Remove and Replace)
Correction Code 12221002
Wing - Lower - Passive Spoiler (Remove & Replace)
Correction Code 12220402
Stanchion - Active Spoiler - LH (Remove and Replace)
Correction Code 12221802
Stanchion - Passive Spoiler - LH (Remove and Replace)
Correction Code 12222002
Torque Rod - Active Spoiler - LH (Remove and Replace)
Correction Code 12221202

Parent topic: 12 - EXTERIOR FITTINGS

2015-2020 Model X Service Manual
Release Notes
- Current Release Notes
- Release Notes Archive
GENERAL INFORMATION
00 - INSPECTION AND SERVICE
10 - BODY
11 - CLOSURE COMPONENTS
12 - EXTERIOR FITTINGS
13 - SEATS
14 - INSTRUMENT PANELS AND PEDALS
- 1405 - Instrument Panel
15 - INTERIOR TRIM
16 - BATTERY SYSTEM
17 - ELECTRICAL
18 - THERMAL MANAGEMENT
20 - SAFETY AND RESTRAINT
21 - INFOTAINMENT
30 - CHASSIS
- 3001 - Chassis and Subframes
31 - SUSPENSION
32 - STEERING
- 3201 - Steering Rack and Lower Column
- 3205 - Upper Column, Steering Wheel
33 - BRAKES
34 - WHEELS AND TIRES
39 - FRONT DRIVE UNIT
40 - REAR DRIVE UNIT
44 - HIGH VOLTAGE SYSTEM
50 - EXTERNAL CHARGING CONNECTORS

Torque Calculator Values

T1 (Original torque spec)

L (Distance from center of wrench grip to center of square drive tang)

E (Horizontal distance from center of square drive tang to center of fastener)

Note

If the angle from the extension to the torque wrench is greater than 90° (Figure 2), input E as a positive number.
If the angle from the extension to the torque wrench is less than 90° (Figure 3), input E as a negative number.
If the angle from the extension to the torque wrench is exactly 90°, this calculator is not needed. Torque the fastener to T1.

T2 (Final torque setting)