03/03/2020 13:18:43

Actuator - Latch - Hood - Primary (Remove and Replace)

Correction Code 11352202

Removal

  1. Remove the front underhood storage unit (refer to procedure).
  2. Release the primary hood latch cable end from the latch.
  3. Use a trim tool to remove the tow hook cover.
    Informational PurposesAn informational icon, calling your attention
    Note
    Insert the trim tool into the notch at the top right portion of the tow hook cover.
  4. Release the straps from the tow hook cover and move them through the tow hook opening.
  5. Remove the bolts (x3) that secure the actuator assembly bracket to the front end module (torque 10 Nm).
  6. Lift the actuator assembly bracket into a working position.
  7. Separate the manual release strap from the primary actuator assembly bracket retainer.
  8. Disconnect the electrical harness from the primary actuator connector.
  9. Slide the black cap from the primary actuator onto the primary cable.
  10. Release the clip that secures the actuator clevis to the primary actuator, and then slide the clevis off of the actuator.
  11. Remove the screws (x2) that secure the primary actuator to the actuator assembly bracket.
  12. Slide the primary actuator out from under the actuator assembly bracket retainer, and then remove the actuator from the vehicle.

Installation

Installation procedure is the reverse of removal.