03/03/2020 13:18:43

Fascia Assembly - Front (Remove and Replace)

Correction Code 10011002

Removal

Remove the front fascia assembly (refer to procedure).
Remove the fascia valance (refer to procedure).
Remove all park assist sensors (refer to procedure).
Remove the upper grille bright trim and center fascia bracket (refer to procedure).
Remove the upper fog light spears (refer to procedure).
Remove the lower fog light spears (refer to procedure).

Installation

Installation procedure is the reverse of removal, except for the following:

CAUTION

Care must be taken to avoid damage to paintwork and exterior trim.

CAUTION

Replace any broken clips.

Transfer all components to the new front fascia.
Perform a radar sensor calibration only if the front radar sensor likely moved outside of its calibration tolerance (due to front end collision, contact while removing the fascia, etc.). See Calibration - Front Radar Sensor.

Note
If radar sensor calibration is required, add the correction code separately.