17/08/2022 00:44:37

Panel - Aero Shield - Mid (Retrofit)

Correction Code 12030506

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
"Jack mode" must be activated on vehicles with air suspension before lifting the vehicle. Failure to do this might lead to suspension damage and could cause serious personal injury.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Use a face shield when performing this procedure.
Informational PurposesAn informational icon, calling your attention
Note
Vehicles with air suspension might need the suspension to be set to "High" or "Very High" to allow the vehicle to be positioned and supported correctly on a vehicle lift.

Removal

  1. Remove the middle shield panel(refer to procedure).
  2. On both sides of the vehicle, remove the bolts (x6) that secure the mid aeroshield reinforcement to the mid aero shield (torque 6 Nm), then remove and discard the reinforcement .
    Figure 1. LH shows, RH is similar
  3. Apply masking tape to LH and RH rear wheelhouse liner.
    Informational PurposesAn informational icon, calling your attention
    Note
    Size of the tape is 20cm x 5cm .
    Figure 2. LH shows, RH is similar
  4. Measure 120 mm from rear screw hole and mark, and 30 mm from cut mark create 6 mm hole mark.
    Figure 3. LH shows, RH is similar
  5. Drill a 6mm new bolt hole for LH and RH rear wheelhouse liner.
    Informational PurposesAn informational icon, calling your attention
    Note
    The hole is 30 mm from the cut mark.
    Figure 4. LH shows, RH is similar
  6. Cut and discard excess LH and RH rear wheelhouse liner.
    Informational PurposesAn informational icon, calling your attention
    Note
    Cut along 120 mm mark to top of template, cut across top of template.

Installation

  1. On both sides of the vehicle, install the bolts (x6) that secure the mid aeroshield reinforcements to the mid aero shield (torque 6 Nm), then install the new reinforcements .
    Figure 5. LH shows, RH is similar
  2. Install the middle shield panel(refer to procedure).