11/05/2022 01:51:47

Trim - Cushion - 2nd Row - LH (Bench Seat) (Remove and Replace)

Correction Code 13086502

Removal

  1. Remove the LH 2nd row bench seat assembly. See Seat Assembly - 2nd Row - LH (With 2nd Row Bench Seats) (Remove and Install).
  2. Return the LH bench seat to an upright position.
  3. Remove the RH side seat cover from the LH bench seat.
  4. Disconnect the center seat buckle connector.
  5. Loosen the bolt that attaches the center seat buckle to the seat frame (torque 45 Nm), and then remove the seat buckle.
  6. Push the outer side of the LH seat cushion inward and loosen the spring clip of the seat assembly release handle, and then remove the release handle.
  7. Release the push clip at the front of the outer side seat trim and loosen the bolt at the rear (torque 6 Nm), and then remove the outer side trim.
  8. Loosen the bolt (torque 45 Nm) of the LH seat belt, and then remove the seat belt from the LH seat.
  9. Loosen the J-hooks (x6) that attach the rear lower seat cover to the seat, and then release the lower cover.
  10. Loosen the J-hooks (x11) that attach the upholstery to the underside of the bench seat.
  11. Disconnect the connectors (x4) for the seat heat pads and occupancy sensors.
  12. Remove the cushion trim assembly from the LH rear seat.

Installation

Installation procedure is the reverse of removal, except for the following:

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Replace any broken clips.