01/10/2020 18:04:36
60/40 Seat Switch - 2nd Row - LH (Remove & Replace)
Correction code 13024652
Warning
This procedure is a DRAFT,
although it has been validated. Warnings and Cautions might be missing. Follow safety
requirements and use extreme caution when working on or near high voltage systems and
components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
-
Using MCU, open all doors
-
Remove outer Escutcheon from the seat back
-
Fold down 60 seat
-
Release rear toe kick from 60 seat assembly
Note6x J-hooks, Release lower outer two to expose inner 4 clips
-
Release the J-hook securing the seat trim together
Note1x J-hook
-
Unzip the seat back trim
Note2x zippers
-
Flip seat trim over
-
Remove the hard plastic seat back from the frame
Note11x clips
-
Remove the switch from the escutcheon house by pressing the tabs in to release the switch
Note2x tabs
-
Disconnect switch
Note1x connector
-
Connect the switch
Note1x connector
- Install switch in to the escutcheon housing
-
Install the hard plastic seat back to the frame
Note11x clips
- Flip seat trim over the seat
-
Zip up the seat back over
Note2x zippers
-
Connect the J-hook on the seat back trim
Note1x J-hook
-
Secure toe kick to 60 seat assembly
Note6x J-hooks, Secure inner 4 clips, then lower outer 2
-
Unfold the 60 seat assembly
- Remove outer Escutcheon from the seat back
- Using MCU close all doors