03/03/2020 13:18:43

Cable - Recliner - 3rd Row Seat - LH (Remove and Replace)

Correction Code 13032002

Remove

  1. Remove the seat back carpet (refer to procedure).
  2. Release the clips that secure the seat fabric to the seat back panel.
  3. Use a drill with a 3/16 in (5 mm) bit to drill out the rivets that secure the seat back panel tot the seat frame.
  4. Release the harness clip from the seat back panel.
  5. Carefully separate the seat back panel from the seat frame to access the release cables.
  6. Cut the cable tie and separate the recliner cables from the seat back panel.
  7. Remove the seat back panel from the seat frame.
  8. Remove the fasteners that secure the recliner actuator to the seat frame. Set aside the recliner actuator.
  9. Disconnect the electrical connector from the recliner actuator.
  10. Separate the release cable from the recliner actuator, and then remove the actuator from the vehicle.
  11. Release the LH and RH recliner cables from the seat frame, and then remove the cables from the vehicle.
  12. Remove and discard the bolt that secures the seat belt assembly to the seat frame (torque 45 Nm). Set aside the seat belt assembly.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Replace all patchbolt(s).
    Informational PurposesAn informational icon, calling your attention
    Note
    The following steps are necessary in order to fully remove the debris from the seat frame.
  13. Remove the fasteners that secure the headrest actuator to the seat frame.
  14. Remove the headrest actuator from the seat frame.
  15. Clean the debris from the seat frame area with a vacuum.

Installation

Installation procedure is the reverse of removal.