25/05/2022 07:25:32

Pinch Sensor Carrier (2nd row) - Rear - LH (Remove and Replace)

Correction Code 11354602

Removal

  1. Remove the LH rear window. See Door Glass - LH - Rear (Remove and Replace)
  2. Disconnect 12V power. See Disconnect 12V Power.
  3. Disconnect the pinch sensor electrical connector.
  4. Release the tabs that attach the pinch sensor carrier harness to the body.
  5. Use a trim tool to release the push clips (x7) that attach the pinch sensor carrier to the door.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Care must be taken to avoid damage to paintwork and exterior trim.
  6. Release the pinch sensor harness grommet by pulling it away from the door. Pull the pinch sensor harness out through the grommet in the rear of the door shell.
  7. Remove the pinch sensor carrier from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Replace any broken clips.
  1. Perform a functional check of the rear door. Make sure that the pinch strip sensors are fully functional.