03/03/2020 13:18:43

Pipe - High Pressure - Compressor to Condenser (Remove and Replace)

Correction Code 18204202

Removal

  1. Remove the cooling fan module (refer to procedure).
  2. Remove the bolts (x4) that secure the plastic support beam to the body of the vehicle (torque 6.5 Nm).
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not attempt to remove the plastic support beam from the vehicle.
  3. Carefully pull the plastic support beam forward to gain access to the compressor-to-condenser high pressure pipe.
  4. Remove the nut that secures the compressor-to-condenser high pressure pipe to the compressor (torque 10 Nm).
  5. Disconnect the pressure sensor electrical connector.
  6. Remove the compressor-to-condenser high pressure pipe from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:

Informational PurposesAn informational icon, calling your attention
Note
Inspect the O-rings. Replace as necessary.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Lubricate new O-rings with clean refrigerant oil.
  1. Recharge the refrigerant.