Model X Service Manual

BEST PRACTICES

Air Bag and Supplementary Restraint System (SRS) Precautions
Air Conditioning System Precautions
Consumable Parts
Diagnostic Connector Location
Electrical Precautions
Environmental Precautions
Ergonomic Precautions
Event Data Recorder Retrieval
Flexible Pipes and Hoses
General Fitting Instructions
General Precautions
Locking Devices
Oil Seals
Personal Protection
Pre-Installation Glass Inspection
This procedure explains how to inspect new windshield, roof, door, and fixed glass components before the new component is installed.
SRS Component Replacement Policy
Vehicle Cameras and Autopilot
Wheels and Tires

Parent topic: GENERAL INFORMATION

2015-2020 Model X Service Manual
Release Notes
GENERAL INFORMATION
00 - INSPECTION AND SERVICE
10 - BODY
11 - CLOSURE COMPONENTS
12 - EXTERIOR FITTINGS
13 - SEATS
14 - INSTRUMENT PANELS AND PEDALS
- 1405 - Instrument Panel
15 - INTERIOR TRIM
16 - BATTERY SYSTEM
17 - ELECTRICAL
18 - THERMAL MANAGEMENT
20 - SAFETY AND RESTRAINT
21 - INFOTAINMENT
30 - CHASSIS
- 3001 - Chassis and Subframes
31 - SUSPENSION
32 - STEERING
- 3201 - Steering Rack and Lower Column
- 3205 - Upper Column, Steering Wheel
33 - BRAKES
34 - WHEELS AND TIRES
39 - FRONT DRIVE UNIT
40 - REAR DRIVE UNIT
44 - HIGH VOLTAGE SYSTEM
50 - EXTERNAL CHARGING CONNECTORS

Torque Calculator Values

T1 (Original torque spec)

L (Distance from center of wrench grip to center of square drive tang)

E (Horizontal distance from center of square drive tang to center of fastener)

Note

If the angle from the extension to the torque wrench is greater than 90° (Figure 2), input E as a positive number.
If the angle from the extension to the torque wrench is less than 90° (Figure 3), input E as a negative number.
If the angle from the extension to the torque wrench is exactly 90°, this calculator is not needed. Torque the fastener to T1.

T2 (Final torque setting)>